Tracker Off-Road 800SX Service Manual page 52

3. Remove the key switch locking nut by turning coun-
terclockwise; then push the key switch through hole
to clear the lower dashboard; then disconnect the
electrical connectors on the left side of the dash-
board.
MOD266
MOD265
4. Remove the five cap screws along the bottom of the
lower dashboard; then remove the lower dashboard
taking note of the tabs on each side of the lower
dashboard.
MOD268A
50
MOD267
INSTALLING
1. Position the lower dashboard into place taking note
of the tabs on each side of the lower dashboard.
Install the five cap screws along the bottom of the
lower dashboard.
MOD267
MOD268A
2. Reinstall the key switch into the key switch cut out;
then secure by turning the locking nut clockwise;
then reconnect the electrical connectors on the left
side of the dash.
 NOTE: The 4WD/2WD switch should be installed in
the outermost switch slot on the left side of the dash
and plugged into the connector that has white/green,
black, and orange/gray wires. The LOCK/UNLOCK
switch should be installed in the innermost switch slot
on the left side of the dash and plugged into the con-
nector that has yellow/orange, black, and orange/gray
wires.