Servicing Left-Side Components - Tracker Off-Road 800SX Service Manual

MOD602
MF019A
12. Connect the coolant temperature connector (4) to the
coolant temperature sensor.
MF133B
13. Install the coolant bypass hose (3) and the coolant
hose (2) onto the thermostat housing. Tighten the
clamps securely.
MF133A
84
14. Fill the cooling system with the appropriate quantity
and mixture of coolant and install the coolant cap;
then bleed the cooling system
15. Install the driver- and passenger-side rear inner fend-
ers.
Servicing Left-Side
Components
 NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to be
addressed and to service only those components. The
technician should use discretion and sound judgment.
AT THIS POINT
To service any one specific component, only limited
disassembly of components may be necessary. Note
the AT THIS POINT information in each sub-section.
 NOTE: The engine does not have to be removed
from the frame for this procedure.
AT THIS POINT
If the technician's objective is to service/inspect the
drive belt, drive belt cover, driven pulley, or drive clutch,
see Periodic Maintenance/Tune-Up.
CLUTCHES
Removing
1. Tilt the cargo box up.
2. Remove the driver-side rear inner fender by rotating
the 1/4-turn fasteners counterclockwise.
MOD606
3. Loosen the clamp that holds the snorkel portion to
the air inlet; then disconnect snorkel portion from air
inlet.