Tracker Off-Road 800SX Service Manual page 75

MF075A
6. Inspect shim for its size; then calculate which shim
needs to be installed (see Calculating Shim to Install
in this section).
7. Replace the removed shim(s) with the proper thick-
ness shim as calculated; then tighten the camshaft
bearing cap screws to specifications using the
sequence shown making sure that camshaft gear tim-
ing marks are correctly aligned.
 NOTE: It is recommended that the cap screws be
tightened in several increments to allow the camshafts
to be evenly seated in the camshaft bearings.
MF098B
MF108A
8. Apply a thin bead of high temperature silicone seal-
ant to the cylinder head as shown; then install the
drive end camshaft bearing housing and tighten the
five cap screws to specifications in the sequence
shown.
MF125A
MF111B
9. Install the camshaft drive and driven pulleys.
MF093
MF092
10. Tighten the camshaft drive pulley bolt to specifica-
tions; then install the camshaft drive belt making
sure the camshafts are correctly timed to the crank-
shaft (see REMOVING AND INSTALLING CAM-
SHAFT DRIVE BELT in this section).
73