Tracker Off-Road 800SX Service Manual page 16

MOD097A
3. Install the rubber boot making sure it is sealed
around the bulb and connect the wire harness.
MOD098A
4. Adjust the headlight (see Checking/Adjusting Head-
light Aim in this sub-section.
Taillight/Brake Light Assembly
If one or more individual LED bulbs are not working, the
taillight/brake light assembly must be replaced.
MOD096
To replace the taillight/brake light assembly, use the fol-
lowing procedure:
1. Remove the four screws from the inner cargo box
side panel, two rear tie-down screws and one tailgate
latch bail screw; then remove the six screws from the
underside of the cargo box and remove the outer
cargo box side panel.
14
MOD114A
MOD115A
2. Remove screw (A); then flex the cargo box fender
away from the cargo box to access and remove screw
(B).
 NOTE: A long extension with a T25 socket or long
T25 screwdriver will be needed to access screw (B).
MOD117A
MOD113