Tracker Off-Road 800SX Service Manual page 87

MOD205A
4. Remove the six clamps securing the clutch cover;
then remove clutch cover.
NOTE: Firmly grasp clamps as they can completely

detach from clutch cover assembly and spring away.
MOD533
5. Using the Drive and Driven Clutch Holder Tool to
hold the driven clutch remove the cap screw securing
the driven clutch.
MOD599
MOD213
6. Remove the belt by pulling it over the driven clutch
and rotating the driven clutch.
MOD215
7. With the driven clutch still on the transaxle input
shaft, place the Drive and Driven Clutch Holder Tool
on the drive and driven clutch to hold the drive
clutch in place; then with a Torx T-60 drive, remove
the cap screw securing the drive clutch. Account for
the washer.
MOD390
8. Lightly coat the threads and the end of the Drive
Clutch Puller Tool with grease. Insert the Drive
Clutch Puller Tool into the drive clutch. Tighten the
Drive Clutch Puller Tool to remove the drive clutch.
NOTE: It may be necessary to strike the end of the

Drive Clutch Puller Tool with a hammer to remove
the drive clutch from the PTO shaft.
MOD391
9. Remove the Drive and Driven Clutch Holder Tool,
drive clutch, driven clutch, and Drive Clutch Puller
Tool.
85