Tracker Off-Road 800SX Service Manual page 59

MOD280A
4. Remove the two cap screws on each seat belt guide;
then remove seat belt guides; then disconnect the
seat belt electrical connector.
MOD282
5. Remove the cap screw on each of the outer portions
of the behind-the-seat storage box panel.
MOD283
6. Disconnect the two electrical connections to the
ECU (A) that is located in front of the engine air fil-
ter.
MOD593
7. Remove the six cap screws securing the behind-the-
seat storage box panel; then remove the eight cap
screws securing the behind-the-seat storage box
panel to the floor; then remove the behind-the-seat
storage box panel.
 NOTE: When removing the behind-the-seat storage
box panel, it might be necessary to gently pull down
on the top of the panel to clear the metal channel that
connects the left and right rear ROPS.
MOD610
INSTALLING
1. Gently position the behind-the-seat storage box
panel into position; then reinstall the six cap screws
on the top of the panel; then install the eight cap
screws securing the behind-the-seat storage box
panel to the floor.
MOD610
2. Reinstall the cap screw on each of the outer portions
of the behind-the-seat storage box panel.
MOD283
3. Reinstall both seat belt guides; then reinstall the two
cap screws on each seat belt guide; then connect the
seat belt electrical connector.
57