Tracker Off-Road 800SX Service Manual page 63

MOD391
3. Near the engine PTO, remove the retaining ring
securing the inner clutch cover to the engine; then
near the transaxle input shaft remove the four cap
screws securing the inner clutch cover to the tran-
saxle; then remove the inner clutch cover.
MOD392
MOD393
4. Disconnect the battery connections; then disconnect
the starter wire (A) and start relay wire (B).
MOD538
5. Remove the flywheel cover; then remove the PTO
stub shaft; then remove the crank position sensor
from the crank position sensor bracket.
MOD539
MOD540
MOD541A
6. Remove the flywheel; then with a suitable lift put a
slight upward tension on the engine; then with a suit-
able strap or lift put a slight upward tension on the
transaxle.
MOD542
61