Tracker Off-Road 800SX Service Manual page 159

TA131A
NOTE: Use a suitable bearing seal protection tool

when driving the bearing and gears into the lower
half of the transaxle.
7. Clean any silicone residue from the case halves.
DISASSEMBLING HALVES
1. Remove the shift shaft assembly and the detent.
TA006A
2. Remove the park pawl with dowel pin and account
for the spring.
TA028B
3. Remove the output gear assembly with bearings.
MOD383
4. Lift on the shift rail assembly to disengage the rail
assembly from the case and rotate the rail away from
the shift drum; then remove the shift drum assembly.
NOTE: Spread the shift forks while removing.

TA022A
5. Using an assistant, lift and remove all remaining
shafts simultaneously.
TA059
6. Place the transaxle upright on the bench and dump
any remaining fluid into the pan.
AT THIS POINT
If the pinion shaft and gear are not being serviced or
replaced, no further disassembling is required.
7. With the transaxle flat on the bench, remove the four
screws securing the pinion gear assembly.
157