Tracker Off-Road 800SX Service Manual page 98

MOD550
5. Located on the PTO side, install the two cap screws
with blue Loctite #243 with the spacers between the
engine and transaxle. Tighten to 75 ft-lb (102 N-m).
MOD554
MOD543
6. With a new exhaust gasket, position the exhaust to
the exhaust manifold; then install the two cap screws
and nuts securing the exhaust to the exhaust mani-
fold. Tighten to 45 ft-lb (61.2 N-m).
7. Remove the tape or other suitable means that was
used to plug the intake for the engine.
96
MOD548
8. Install the air intake to the engine and tighten clamp.
MOD545A
9. Remove the suitable strap putting a slight upward
tension on the engine; then remove the suitable strap
putting a slight upward tension on the transaxle; then
install the flywheel and evenly tighten cap screws to
51.7 ft-lb (70 N-m).
MOD546
MOD542