Tracker Off-Road 800SX Service Manual page 93

MOD209
FLYWHEEL
 NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to be
addressed and to service only those components. The
technician should use discretion and sound judgment.
NOTE: The engine does not have to be removed

from the frame for this procedure.
 NOTE: The ring gear is only serviceable as an
assembly with the flywheel.
Removing
1. Tilt the cargo box up and remove the driver-side rear
inner fender; then remove the clutch cover, drive
belt, drive clutch, and driven clutch.
2. Near the engine PTO, remove the retaining ring
securing the inner clutch cover to the engine; then
near the transaxle input shaft, remove the four cap
screws securing the inner clutch cover to the tran-
saxle; then remove the inner clutch cover.
MOD392
MOD393
3. Remove the cap screws securing the flywheel cover;
then remove the flywheel cover; then remove the two
cap screws securing the crankshaft position sensor
bracket; then remove the crankshaft position sensor
from the crankshaft position sensor bracket.
MOD539
MOD541A
4. Using a suitable tool to hold the PTO/flywheel in
place, remove the four cap screws securing the PTO
stub shaft to the flywheel; then remove the six cap
screws securing the flywheel to the crankshaft.
MOD540
91