Front Differential Lubricant - Transaxle Fluid - Tracker Off-Road 800SX Service Manual

MOD064
4. Remove the drain plug from the bottom of the engine
and drain the oil into a drain pan.
MOD020A
5. Using the oil filter wrench and a ratchet handle (or a
socket or box-end wrench), remove the old oil filter
and dispose of properly. Capture oil in a suitable pan
or absorbent material. Do not re-use oil filter.
MOD106
NOTE: Clean up any excess oil after removing the

filter.
6. Apply oil to the new filter O-ring and check to make
sure it is positioned correctly; then install the new oil
filter. Tighten securely.
7. Install the engine drain plug and tighten to 36.9 ft-lb
(50 N-m). Pour the recommended oil into the filler
hole. Install oil fill cap.
8. Start the engine (while the vehicle is outside on level
ground) and allow it to idle for a few minutes.
9. Turn the engine off and wait approximately one min-
ute. Recheck the oil level.
12
10. Inspect the area around the drain plug and oil filter
for leaks.
11. Install the maintenance cover.
12. Check to make sure the oil fill cap is secure and the
oil level stick is installed correctly; then lower the
cargo box to its locked down position.
Front Differential Lubricant
— Transaxle Fluid
INSPECTING/CHANGING
Inspect and change the lubricant/fluid in each according
to the Maintenance Schedule. Use the appropriate lubri-
cant and the following procedure:
1. Place the vehicle on level ground; then remove the
fill plugs on the front differential (A) and transaxle
(C).
MOD073A
MOD058A
2. Drain the lubricant/fluid into a drain pan by remov-
ing the drain plugs from the right-side front differen-
tial (E) and transaxle (D).