Tracker Off-Road 800SX Service Manual page 32

2. Insert the CV shaft into the knuckle; then install the
knuckle to the upper and lower ball joints and secure
with the two cap screws and two new lock nuts.
Tighten to 45 ft-lb (61.2 N-m).
MOD325
3. Install the tie rod end and secure with the nut (coated
with red Loctite #271). Tighten to 32 ft-lb (43.5 N-m);
then install a new cotter pin and spread the pin.
4. Apply a small amount of molybdenum grease to the
hub splines.
MOD328
5. Install the hub assembly onto the splines of the shaft.
MOD329
6. Using Hub Retaining Wrench, secure the hub assem-
bly with the nut. Tighten to 250 ft-lb (339 N-m).
30
MOD330
7. Install the retaining plate.
 NOTE: If necessary, tighten the hub nut clockwise
to allow the retaining plate to sit flush with the hub.
MOD331
MOD332
8. Secure the brake caliper to the knuckle with the two
new "patch-lock" cap screws. Tighten to 45 ft-lb
(61.2 N-m).
MOD301