Shift Cable - Tracker Off-Road 800SX Service Manual

8. Start at the rear of the cargo box and tuck the outer
side panel under the cargo box floor and work it into
place from back to front.
MOD111
9. Once the outer side panel is in place, install the
screws securing the cargo box fender and outer side
panel.
MOD114A
MOD115A
Checking/Adjusting Headlight Aim
The headlights can be adjusted vertically. The geometric
center of the HIGH beam light zone is to be used for aim-
ing.
1. Position the vehicle on a level floor so the headlights
are approximately 6.1 m (20 ft) from an aiming sur-
face (wall or similar aiming surface).
16
MOD38
NOTE: There should be an average operating load

on the vehicle when adjusting the headlight aim.
2. Measure the distance from the floor to the midpoint
of each headlight.
3. Using the measurements obtained in step 2, make
horizontal marks on the aiming surface.
4. Make vertical marks which intersect the horizontal
marks on the aiming surface directly in front of the
headlights.
5. Switch on the lights. Make sure the HIGH beam is
on. DO NOT USE LOW BEAM.
6. Observe each headlight beam aim. Proper aim is
when the most intense beam is centered on the verti-
cal mark 5 cm (2 in.) below the horizontal mark on
the aiming surface.
7. Turn the headlight adjustment cap screw clockwise
to adjust the headlight aim down or counterclock-
wise to adjust the headlight aim up .
MOD046A

Shift Cable

CHECKING SHIFT CABLE
Turn the ignition switch on; then shift the transmission
into park. The letter P should illuminate on the LCD
gauge and the park icon (P) should illuminate. The vehi-
cle should not be able to move.