Tracker Off-Road 800SX Service Manual page 44

MOD592
4. Install the four cap screws in the inner fender.
MOD137A
5. Gently pull on the front portion of the side panel;
then install the cap screw securing the fender to the
frame.
 NOTE: A 1/4-in. driver bit is recommended to
access this cap screw. More side panel cap screws will
need to be removed to make room for a larger tool.
MOD142
6. Install the three shouldered cap screws from the top
of the side cover and the two shouldered cap screws
from the bottom of the side cover.
42
MOD262
7. Located in the front of the inner fender, install the
two cap screws securing the fender, fender flare and
grille to the headlight bracket. Install the upper hood,
mid/upper dashboard and hood; then adjust doors as
needed.
MODC056
Side Panels
REMOVING
1. Tilt the cargo box into the up position; then remove
the rear inner fender; then remove the cap screws
behind the rear ROPS mounting point.
MOD190
2. Remove the three cap screws from inside the behind
seat storage.