Tracker Off-Road 800SX Service Manual page 135

Display Fault Description
U0100 Lost Communication with ECM
U0155 LCD Gauge to ECM CAN Communication
Lost
U1000 Vehicle Not Registered or Invalid PIN
Entered
U1001 Vehicle Not Registered, Engine Hours
Exceed 5 Hours
FUEL OFF Tilt Sensor Activation Code
High: A high voltage condition has been detected.
Low: A low voltage condition has been detected.
Intermittent: An intermittent circuit condition has been detected.
Open: An open circuit condition has been detected.
Possible Cause
The ECM CAN circuit or its interconnect harness is intermittent or
has failed.
The LCD gauge CAN circuit or its interconnect harness is
intermittent or has failed.
A valid registration PIN has not yet been entered
A valid registration PIN has not yet been entered
The chassis tilt sensor has been activated.
* After correcting the condition, cycle the key switch On-Off-On.
**After correcting the condition, cycle the key switch On-Off-On, start the
Enter the correct
Enter the correct
engine and drive vehicle, then cycle the key switch On-Off-On.
Fault Recovery Method
Correct condition*
Correct condition*
registration PIN*
registration PIN*
Correct condition*
133