Tracker Off-Road 800SX Service Manual page 48

MOD592
3. Remove the six fasteners on the occupant side secur-
ing the splash panel to floor.
MOD287
MOD288
4. Remove the two cap screws located near the front
tires securing the splash panel to floor on each side.
MOD289A
5. Remove the one cap screw located near the rearmost
corner of the floor on each side.
46
MOD290
6. Remove the seven cap screws securing the floor to
frame.
MOD291
MOD292
7. Gently lift the rear of the floor up and lift the floor
out of the vehicle.
CLEANING AND INSPECTING
1. Clean the floor with soap and water.
2. Inspect the floor for cracks or holes.
INSTALLING
1. Place the front of the floor into position in the vehi-
cle first; then lower the rear; then fasten the seven
cap screws securing the floor to frame.