Front Fenders/Fender Flares - Tracker Off-Road 800SX Service Manual

Front Fenders/Fender
Flares
Removing the fender is recommended to remove the
fender flare
REMOVING
1. Remove the hood, upper hood and mid/upper dash-
board. Located in the front of the inner fender,
remove the two cap screws securing the fender,
fender flare and grille to the headlight bracket.
MODC056
2. Remove the three shouldered cap screws from the
top of the side cover and the two shouldered cap
screws from the bottom of the side cover.
MOD262
3. Gently pull on the front portion of the side panel;
then remove the cap screw securing the fender to the
frame.
NOTE: A 1/4-in. driver bit is recommended to

access this cap screw. More side panel cap screws will
need to be removed to make room for a larger tool.
40
MOD142
4. Remove the four cap screws from the inner fender.
MOD137A
5. Remove the three cap screws indicated.
MOD592
6. Remove the two remaining cap screws on the top
portion of the fender; then remove fender. If fender
flare removal is desired, continue to step 7.
MOD150A