Winch - Tracker Off-Road 800SX Service Manual

3. Connect the red tester lead to the blue/brown wire
(B) and the black tester lead to the pink/black wire
(A); then turn the ignition switch ON and observe the
meter. The meter should read 0.4-1.4 DC volts.
MOD490A
4. Tilt the sensor 60° or more to the left and right
observing the meter. The meter should read 3.7-4.4
DC volts after approximately one second in the tilted
position. If the meter readings are not as specified,
the tilt sensor is defective.
MOD490B
NOTE: When replacing the sensor after testing,

make sure the arrow marking is directed up.

Winch

NOTE: The winch is only serviceable as an assembly.

REMOVING
1. Disconnect the battery; then remove the front bumper.
2. Remove the four cap screws securing the winch to the
winch bracket; then remove the two electrical cables
attached to the winch.
MOD693A
MOD695A
3. Remove the passenger-side bumper bracket; then gently
slide the winch out the passenger side of the vehicle.
MOD694
INSTALLING
1. Position the winch into place by gently sliding the
winch from the passenger side.
2. Install the two power cables to the winch; then install
the four cap screws securing the winch to the winch
bracket.
3. Install the passenger-side bumper bracket. Do not
tighten at this time; then install the bumper; then tighten
all fasteners; then reconnect battery.
123