Tracker Off-Road 800SX Service Manual page 165

3. With the aid of an assistant and using an appropriate
driver, remove the gear.
TA031
4. Remove the large outer snap ring and account for the
shim.
TA086
5. Using an appropriate bearing driver, press the bear-
ing from the housing.
TA081
6. Using an appropriate bearing installer, install a new
bearing into the housing.
TA132
7. Install the large outer snap ring with the shim.
TA086
8. Install the gear into the housing.
TA077
9. Install the small inner snap ring with shim.
BACKLASH
AT THIS POINT
If the pinion shaft or gear were replaced or serviced,
backlash must be checked. If not, proceed to ASSEM-
BLING HALVES in this section.
1. Install the pinion shaft into the case. With the appro-
priate shim in place, secure with the snap ring.
163