Tracker Off-Road 800SX Service Manual page 76

MF087B
MF088B
11. Install the camshaft drive belt guide with the tapered
circumference directed away from the drive pulley.
MF161A
12. Install the upper and lower drive belt covers (E) and
tighten the cap screws securely.
MF084A
74
13. Install the water pump drive pulley (C) and crank-
shaft drive pulley (D) and tighten the water pump
pulley cap screws and crankshaft drive pulley bolt to
specifications.
MF081A
14. Install the serpentine belt and tighten as required.
MF079
15. Install the valve cover and tighten to specifications.
REMOVING AND INSTALLING
CAMSHAFTS/VALVE BUCKETS
NOTE: The engine does not need to be removed

from the vehicle for this procedure.
1. Disconnect the negative battery cable from the bat-
tery; then remove the camshaft drive belt (see
REMOVING AND INSTALLING CAMSHAFT
DRIVE BELT in this section).
2. Remove valve cover (see Removing Valve Cover in
this section).
3. Remove five cap screws securing the drive end cam-
shaft housing and remove the housing.
 NOTE: The cap screws are different lengths and
must go back to their respective place.