Tracker Off-Road 800SX Service Manual page 81

MF133B
MF019A
9. Disconnect the air inlet tube from the intake mani-
fold; then disconnect the throttle body (TB) connec-
tor (6).
MF134A
10. Disconnect the three fuel injector connectors (7);
then disconnect the temperature/manifold absolute
pressure (TMAP) connector (5).
MF144A
11. Remove the camshaft drive belt (see REMOVING
AND INSTALLING CAMSHAFT DRIVE BELT in
this section).
12. Remove camshafts
INSTALLING CAMSHAFTS in this section).
13. Remove the eight head bolts securing the cylinder
head to the cylinder block in the sequence shown.
Account for the hardened washers on each head bolt.
MF113B
14. Carefully lift the cylinder head from the cylinder
block. Account for and note the orientation of the
head gasket (8) relative to the oil supply port (9) and
a formed weather seal (10).
MF140A
15. Remove and discard the coolant O-ring (11).
MF123C
16. Remove the heat shield from the exhaust manifold;
then remove the manifold from the cylinder head.
(see REMOVING AND
79