Tracker Off-Road 800SX Service Manual page 25

3. Remove the input shaft cap screw and lock nut of the
EPS; then remove the output shaft cap screw and
lock nut of the EPS. Discard lock nuts. Inspect cap
screws and replace if damaged.
MOD270A
MOD271
4. Remove the two cap screws securing the steering tilt
assembly; then pull the U-joint off of the input shaft
of the EPS; then secure the steering tilt assembly out
of the way.
MOD272
5. Remove the two cap screws on the occupant side and
the one cap screw in the front left inner fender secur-
ing the EPS; then gently remove the EPS taking note
that the output shaft should slide away from the
U-joint.
MOD274
MOD273
INSTALLING STEERING SHAFT/EPS
ASSEMBLY
 NOTE: Both the input and output shafts of the EPS
have a notch that will only align one way with the
U-joints.
MOD275
MOD276
1. Align the steering rack with the marks; then reinstall
the output shaft of the EPS into the U-joint going to
the steering rack; then install the EPS into position.
23