Table of Contents
Advertisement
Replacing FAN08 Modules
Removing FAN08
Modules
This section contains the procedure for replacing FAN08 Modules in the
SBx908 Gen2 Chassis.
This procedure requires the following tool:
#2 Phillips-head screwdriver (not provided)
The illustrations show the removal of the fan module from the Fan A slot
on the back panel. The procedure is the same for removing the module
from the Fan B slot.
To remove an FAN08 Module from the chassis, perform the following
procedure:
1. Use a #2 Phillips-head screwdriver to loosen the two screws on the
faceplate of the fan module. Refer to Figure 122.
Figure 122. Loosening the Screws on the FAN08 Module
2. Carefully pull on the screws on the faceplate to disconnect the line
card from the connector on the backplane in the chassis. Refer to
Figure 123 on page 168.
SBx908 GEN2 Installation Guide for Stand-alone Switches
167
Advertisement
Table of Contents
