Table of Contents
Advertisement
Table 16. Configuring a Member Switch - Part I (Continued)
Step
11
Enter the WRITE command to save your changes. If this is the first management
session, the switch adds the configuration file DEFAULT.CFG to flash memory to
store your configuration changes.
awplus# write
Building configuration ...
[OK]
12
Restart the switch with the REBOOT command.
awplus# reboot
reboot system? (y/n):
awplus#
13
Type "Y" for yes.
14
Wait two minutes for the switch to initialize its management software.
15
Check the ID LED on the front panel and do one of the following:
- If the ID LED is displaying the correct ID number for the member switch, go to
"Configuring a Member Switch - Part II," next.
- If the ID LED is displaying an incorrect number, repeat this procedure. Be sure to
correctly enter the STACK RENUMBER command and to save your changes with
the WRITE command.
- If the ID LED is displaying "0," VCStack is still disabled. Repeat this procedure. Be
sure to perform the STACK ENABLE command and to issue the WRITE command.
Configuring a
Member Switch -
Part II
Description and Command
This section contains instructions to the second part to configuring
member switches. The instructions explain how to do the following:
Set the priority number. Refer to "Master and Member Switches"
on page 58.
Designate the ports of the stack trunk of the member switch. Refer
to "Stack Trunk" on page 44.
Designate the ports of the stack trunk of the provisioned master
switch.
To perform Part II of configuring a member switch, perform the procedure
in Table 17 on page 160.
AT-SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
159
Advertisement
Table of Contents
