Table of Contents
Advertisement
Table 16. Configuring the Master Switch for 5Gbps Stacking Ports - Part I (Continued)
Step
15
Enter the WRITE command to save your change. If this is the first management
session, the switch adds the configuration file DEFAULT.CFG to flash memory, for
storing your configuration changes. If you do not save your changes, they will be
discarded and you will have to reenter them when you reboot the switch later in these
procedures.
awplus# write
Building configuration ...
[OK]
16
Go to "Configuring the Master Switch - Part II," next.
Configuring the
Master Switch -
Part II
Table 17. Configuring the Master Switch for 5Gbps Stacking Ports - Part II
Step
Steps 1 to 2 add the member switches as provisioned switches on the master switch. This is so
the master switch is aware of the switches when the stack is powered on for the first time.
1
Move to the Global Configuration mode with the CONFIGURE TERMINAL command.
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
2
Add the member switches to the master switch as provisioned switches with the
SWITCH PROVISION command. Assign a unique ID number, in the range of 2 to 8,
to each unit. The following example adds three provisioned member switches to the
master switch, with the IDs 2 to 4:
awplus(config)# switch 2 provision x530DP-52
awplus(config)# switch 3 provision x530DP-52
awplus(config)# switch 4 provision x530DP-52
Steps 3 and 4 remove the stacking function from the default stacking ports 51 and 52 on the
provisioned member switches.
3
Enter the port Interface modes of the default stacking ports 51 and 52 on the
provisioned member switches. The example here assumes there are three
provisioned member switches, with the IDs 2 to 4:
awplus(config)# interface port2.0.51-2.0.52,port3.0.51-
3.0.52,port4.0.51-4.0.52
Description and Command
In Part II, you add the member switches as provisioned units to the master
switch and designate their 5Gbps stacking ports. Adding member switches
as provisioned devices ensures that the master switch is aware of them
during the first stack power-on. The procedure assumes you are
continuing directly from the previous procedure.
Description and Command
x530DP Series Installation Guide for Virtual Chassis Stacking
137
Advertisement
Table of Contents
