Configuring The Member Switch - Part Ii - Allied Telesis XS900MX Series Installation Manual

Table 9. Configuring the Member Switch - Part I (Continued)
Step
Step 14 verifies your changes.
14 Check the ID LED on the front panel and do one of the following:
- If the ID LED is displaying 2, go to "Configuring the Member Switch - Part II," next.
- If the ID LED is displaying "0" or a different number, repeat this procedure, being
sure to enter the STACK RENUMBER command and save your changes with the
WRITE command.
Configuring the
Member Switch -
Part II
Step
1 Start a new local management session on the member switch. Refer to "Starting a
Local Management Session" on page 86.
2 Enter the ENABLE command to move from the User Exec mode to the Privileged
Exec mode.
awplus> enable
Steps 3 and 4 set the member switch's priority value to 2, to match its ID number.
3 Move to the Global Configuration mode with the CONFIGURE TERMINAL command.
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
4 Assign the switch the priority value 2 with the STACK PRIORITY:
awplus(config)# stack 2 priority 2
Steps 5 and 6 remove default trunk ports 15/S1 and 16/S2 from the trunk.
5
Enter the port Interface modes of the default trunk ports 15/S1 and 16/S2 on the
member switch:
awplus(config)# interface port2.0.15-2.0.16
% port2.0.15 is currently configured as a stack-port. Use caution
when altering its config.
% port2.0.16 is currently configured as a stack-port. Use caution
when altering its config.
Description and Command
Perform the procedure in Table 10 to perform the second part to
configuring the member switch.
Table 10. Configuring the Member Switch - Part II
Description and Command
XS900MX Series Installation Guide for VCStack
121