Table of Contents
Advertisement
A. Turn on/off the cursors of bode plot
B. Set the cursors type (X or Y)
C. Specify the cursor and set the position (by gestures, universal
knob, or virtual keypad)
D. Set the source 1
E. Set the source 2
F. Return to previous menu
Trace Visibility
When multiple output signals are connected, the bode plot
interface will display the amplitude and phase curves of all output
signals at the same time. Users can turn on/off other scanning
curves to observe the details of specific curves. Touch
Display>Trace Visibility to recall the setting dialog box.
26.4 Data Analysis
With the data list, cursor measurement and automatic measurement functions, the bode
plot curve can be analyzed in detail. The data list provides the information of each
scanning point. The cursors can be used to flexibly measure the change of each position
of the curve. The automatic measurement function can be used to measure the five
parameters of the bode plot curve: Upper cut-off frequency (UF), lower cut-off frequency
(LF), bandwidth (BW), gain margin (GM), phase margin (PM).
1.800.561.8187
information@itm.com
www.
.com
T3DSO2000A Manual. Page 167
Advertisement
Table of Contents
