External Save And Recall - Teledyne LeCroy T3DSO2000A Series User Manual

Save oscilloscope setup to internal memory
Follow the steps below:
A. Select Mode as "Save"
B. Select Type as "Setup"
C. Select Save Path as "Internal"
D. Select No. of internal storage locations, 1~10 optional.
E. Touch Save to perform the save operation
A progress bar is shown when the Save operation is in
progress. When it is done, the oscilloscope prompts "Saved to
internal file No.X", where X is the internal storage location index
selected in the step D.
Recall oscilloscope setup from internal memory
Follow the steps below:
A. Select Mode as "Recall"
B. Select Type as "Setup"
C. Select Recall Path as "Internal"
D. Select No. of internal storage locations, 1~10 optional
E. Touch Recall to perform the recall operation
29.3

External Save and Recall

Before performing an external save or recall, make sure the
USB storage device is connected correctly.
A. Select Save Path as "External"
B. Touch the File Manager and open the file manager. If the U
disk is not properly connected, the system will prompt "USB
flash drive not detected!"
1.800.561.8187
www. .com
information@itm.com
T3DSO2000A Manual. Page 180