Dodge ZB 2005 Service Manual page 755

13 - 4 FRAME & BUMPERS
FRONT FASCIA - EXPORT (Continued)
1 - PUSH ON SPRING NUT
2 - FRAME ASSEMBLY
3 - RIVET NUT
4 - NUT
5 - BOLTS
(6) Install the headlamp washer nozzle covers
(Refer to 8 - ELECTRICAL/WIPERS/WASHERS/
WASHER NOZZLE - INSTALLATION).
FRONT BUMPER
REINFORCEMENT
REMOVAL
(1) Remove the fascia. (Refer to 13 - FRAME &
BUMPERS/BUMPERS/FRONT
REMOVAL)
(2) Remove the bolts and remove the hood release
handle. (Fig. 5)
(3) Remove the nuts and remove the reinforce-
ment. (Fig. 2)
INSTALLATION
(1) Install the reinforcement and install the nuts.
(2) Tighten the nuts to 54 N·m (40 ft. lbs.).
(3) Install the hood release handle and install the
bolts.
(4) Install the front fascia. (Refer to 13 - FRAME
& BUMPERS/BUMPERS/FRONT FASCIA - INSTAL-
LATION)
Fig. 4 FRONT FASCIA
6 - BUMPER REINFORCEMENT
7 - FRONT FASCIA
8 - FRONT BUMPER
9 - SQUARE NECK BOLT
FASCIA -
1 - HOOD REMOTE RELEASE ASSEMBLY
2 - FRONT BUMPER REINFORCEMENT
Fig. 5 HOOD LATCH RELEASE HANDLE
ZB