Dodge ZB 2005 Service Manual page 716

ZB
HYDRAULIC TAPPETS
DESCRIPTION
Fig. 83 Hydraulic Tappets
1 - BOLT
2 - ALIGNING YOKE
3 - HYDRAULIC TAPPET
The roller type design hydraulic tappets (3) are
positioned in the cylinder block. Roller tappet align-
ment is maintained by machined flats on tappet body
being fitted in pairs into ten aligning yokes (2) (Fig.
84).
REMOVAL
(1) Remove cylinder head(s) (Refer to 9 - ENGINE/
CYLINDER HEAD - REMOVAL).
NOTE: If tappets (3) are to be reused, identify tap-
pet location to ensure installation in original loca-
tion.
(2) Remove tappet aligning yoke bolt (1) (Fig. 84).
(3) Remove tappets (3) from bores.
CAUTION: Do not disassemble tappets.
INSTALLATION
(1) Lubricate tappets.
(2) Install tappets in their original positions with
oil holes (1) facing up (Fig. 85).
Fig. 84 Hydraulic Tappets
1 - BOLT
2 - ALIGNING YOKE
3 - HYDRAULIC TAPPET
Fig. 85 Tappet Oil Holes
1 - OIL HOLES UP FOR INSTALLATION
CAUTION: The "handle" on the tappet aligning yoke
must be installed in the outboard position; i.e.
toward the cylinders.
ENGINE 9 - 55