Keysight N9912A User Manual page 41

 Use the ▲|▼ arrows OR
 Press Trace 6 then select
How to maximize the viewing of the active trace
 Press System 7
 Then
 Press any key to return to the standard display.
Quick Settings
Both CAT and NA Modes allow you to view and change most relevant settings from a
single location. All of these settings are discussed in this chapter and, unless
otherwise noted, ALL of these settings can also be made using the standard softkey
menus.
How to view and change Quick Settings
 Press Meas Setup 4.
 Then Settings.
 Press
 To change a setting:
 Press
 When finished changing ALL settings, press
Calibration Settings
NA Mode has a page specifically for making settings that pertain to Port Extensions,
including Velocity Factor and Media Type.
Learn more about Port Extensions on page 48.
NOTE The N9912A does NOT support Media Type: Waveguide.
How to view and change Calibration Settings
 Press Meas Setup 4.
 Then
NA (Network Analyzer) Mode
that are shown can be activated.
Full Screen.
and
Next Page Previous Page
NOT available, then all available settings fit on one page.
Use the ▲|▼ arrows to highlight a setting.
o
Then press Edit. The current setting changes to
o
Some settings require you to press a softkey to change the value. Otherwise, use
o
the numeric keypad, ▲|▼ arrows, or rotary knob to change the value.
When finished changing a value, press
o
to relocate the Settings table to a position relative to the
Dock Window
trace window. The Dock Window setting persists through a Preset. Choose from
the following:
Full (Default setting) Only the Settings table is shown on the screen. The trace
o
window is temporarily not shown.
Left The Settings table is shown to the left of the trace window.
o
Bottom The Settings table is shown below the trace window.
o
Calibration Settings
Trace 1, Trace 2, Trace
to view all settings. If these softkeys are
yellow
Done Edit.
to save your settings.
Done
3, or 4, Only traces
Trace
.
41