Display Settings - Keysight N9912A User Manual

 Then
 Then
How to recall User Preset
 Press Preset .
 Then choose from the following:
NOTES
 Only the instrument settings are saved to UserPreset.sta. No trace data or
 User Preset ON / OFF is saved as a Preference setting. Like all preferences, this
 To return to Factory Preset, select
Volume Control
System volume control is a FieldFox global setting which sets speaker volume for ALL
success beeps, key press clicks, and individual features that use the FieldFox
speaker, such as SA Mode Tune and Listen.
The volume control setting remains through a FieldFox Preset. To cause your volume
control setting to remain through a FieldFox shutdown, save the setting as a
Preference. Learn how on page 174.
How to set FieldFox Volume Control
 Press System 7
 Then
 Then use the ▲|▼ arrows, the rotary knob, or numeric keypad to enter a value
 Press

Display Settings

You can adjust the FieldFox for optimum viewing in a wide range of lighting
conditions.
Display settings remain through a FieldFox Preset. To cause the display brightness,
color settings, and trace width to remain through a FieldFox shutdown, save the
display settings as Preferences. Learn how on page 174..
172
Preset, then select
Save User
User Preset ON
The entire UserPreset.sta file is recalled. ALL modes assume the
Preset (User)
o
settings that were in place when the User Preset was saved. The active mode is
the mode that was visible when the file was saved.
Mode Preset (User)
o
UserPreset.sta.
calibration data is saved.
setting survives a FieldFox shutdown and power ON. Therefore, when User Preset
is ON during shutdown, the FieldFox will load UserPreset.sta when it is powered
ON.
UserPreset.sta remain stored on the FieldFox. When User Preset is OFF, you can
also set the Startup Mode preference that determines which mode will be visible
after powering ON. Learn more on page 164.
Volume
between 0 (lowest volume) and 100 (highest volume).
again and select Mute to quickly turn OFF the speaker volume.
Volume
Press again to set volume ON to the previous volume control.
Volume
to confirm.
Yes
The settings for only the current mode are recalled from
User Preset
OFF. The contents of
FieldFox User's Guide