Keysight N9912A User Manual page 179

NOTE The GPS Sync setting has the same restrictions as the Date and Time setting. Time
can be changed BACK no more than once a day and no more than 6 hours at a time.
Learn more on page 181.



GPS Status
With GPS enabled and a device detected, the following is displayed at the top of the
FieldFox screen:
In the above image, the following icons show if the FieldFox is locked on satellites:
Saving Data with GPS Enabled
GPS position and clock data are included when data is saved with the following files
types: *.csv, *.SnP, State, State+Trace data save.
A warning is shown if the GPS is ON but unlocked at time of save, or if the GPS
feature is ON but no GPS is physically present at time of save.
The following is a sample S1P file with GPS information:
!GPS Latitude: 38 28.87717 N
!GPS Longitude: 122 42.66625 W
!GPS TimeStamp: 06/25/2010 16:24:48
!GPS Seconds Since Last Read: 2
System Settings
The FieldFox clock is synchronized and updated approximately every
ON
o
second to the time of the GPS clock. Learn how to set the local time zone on
page 180.
The FieldFox clock is NOT synched with GPS. When set to OFF after Sync
OFF
o
was ON, the date and time does NOT revert back to the settings before the clock
was synchronized.
Enable and disable the GPS display on the FieldFox main
Display ON OFF
window.
Change the format of the GPS display on the FieldFox screen.
Lat/Lon Format
Choose from:
degrees, minutes, seconds (default setting)
ddd°mm' ss.sss"
o
ddd°mm.mmmmm'
o
decimal degrees
ddd.ddddddd°
o
Choose from:
Elevation Unit
(Meters)
m
o
Feet
o
- GPS ON and locked on satellites
- GPS ON, but NOT locked on satellites
- GPS ON, but no GPS receiver is present or detected
degrees, minutes, fractional minutes
179