Keysight N9912A User Manual page 114

Channel Power Meter Mode - Option 311
Channel Power Meter (also known as CPM or Built-in Power Meter) uses the RF IN
connector to make quick and simple power measurements over a selectable
frequency span. A power sensor is NOT required.
In this Chapter
Set Frequency/Span ........................................... 115
Radio Standard .................................................. 115
Attenuation ......................................................... 116
See Also
The following CPM settings are identical to the standard Power Meter settings.
Learn more about these settings:
Set Scale ............................................................. 119
Set Relative and Offset Power ............................ 120
Set Display Units ................................................ 121
Set Averaging ..................................................... 121
Single/Continuous .............................................. 122
Set Limits ............................................................ 122
CPM Settings
Connect the power to be measured to the RF IN port on the FieldFox top panel.
Select CPM Mode before making any setting in this section.
How to select CPM Mode
 Press Mode_.
 Then CPM.
114 FieldFox User's Guide