System Configuration Options (Licensing) - Keysight N9912A User Manual

 Then
 Then
System Configuration
Options (Licensing)
You can view and install options on your FieldFox. See all available options on page
8.
How to view the Installed Options
 Press System 7
 Then
 Then
 Then
The currently installed options are listed.
How to Install Options
A .lic file must already be on a USB Flash Drive. To learn how to obtain a .lic file,
visit:
Insert the USB Flash Drive in the FieldFox.
 Press System 7
 Then
 Then
 Then
 Press and hold the power button to shutdown, then restart the FieldFox.
How to Delete ALL Options
Deleting individual options is NOT supported.
 Press System 7
 Then
 Then
 Then
 Then
System Settings
Preferences
Battery Saver
ON – Default setting. To conserve battery power, the RF source power is turned
o
OFF at the end of each CAT, NA, and VVM Mode sweep. This behavior does not
impact FieldFox measurements.
OFF – Source power is kept ON at all times, including during trigger Hold mode
o
and between single sweep acquisitions. The RF source stays at the stop
frequency until another sweep begins. This provides a constant, uninterrupted
RF output from the RF OUT port. This behavior also provides the highest trace
stability sweep-to-sweep which may only be evident while using either single
sweep or Run/Hold. With Battery Save OFF, the use of a full battery charge is
reduced by approximately 45 minutes.
System Configuration
Options(Licensing)
Show Options
http://www.keysight.com/find/softwarelicense
System Configuration
Options
The FieldFox reads, validates, then installs the options.
Install Options
System Configuration
Options
Advanced
Delete All Options
177