Matrox Iris GT MIL Installation And Technical Reference page 219

Field name
Default gateway under static IP mode
Network domain under static IP mode
Enable usage of AutoIP
DHCP autoconfig check interval
Last known AutoIP address used
Default subnet mask for AutoIP
Default subnet for AutoIP
Speed and mode selection
Button name
Update TCP/IP settings
Description
Specifies the IP address of the network device that can forward packets from your subnet to
others on the LAN, as needed. Note that if DHCP is enabled, this field is not used.
Specifies the network domain used by your Matrox Iris GT when using a static IP address.
Note that if DHCP is enabled, this field is not used.
Specifies that the DHCP client of your Matrox Iris GT will assign an IP address automatically
when no DHCP server responds. Note that, if this value is disabled, your Matrox Iris GT will
not get an IP address automatically.
Specifies the set amount of time after which your Matrox Iris GT will test the network to see if
DHCP is now available, in secs. The default value is 385 secs.
Specifies the last known IP address used by AutoIP . Note that, if the IP address has recently
changed, you must refresh this page to see the change.
Specifies the last known subnet mask used by AutoIP . Note that, if the IP address has recently
changed, you must refresh this page to see the change. The default is 255.255.0.0.
Specifies the range of IP addresses in which AutoIP will generate your IP address. The default
value is 169.254.0.0. Note that this will change if AutoIP is enabled.
Specifies the speed and connection mode for your network connection. The connection speed
is in Mbits/sec. The connection mode can be either half or full duplex.
• Autodetect. Sets that your Matrox Iris GT will determine the speed and duplex of the
connection, and set it accordingly.
• 10 Mbits half duplex. Sets the connection to 10 Mbits per second at half duplex.
• 100 Mbits half duplex. Sets the connection to 100 Mbits per second at half duplex.
• 10 Mbits full duplex. Sets the connection to 10 Mbits per second at full duplex.
• 100 Mbits full duplex. Sets the connection to 100 Mbits per second at full duplex.
• 1000 Mbits full duplex. Sets the connection to 1000 Mbits per second at full duplex.
Description
Enables changes made on the TCP/IP settings page. Note that you must reboot the operating system for changes
to take effect.
Administration utility page 219