Breakout Board's Output Connector - Matrox Iris GT MIL Installation And Technical Reference

Wire terminal Description
J21 Industrial auxiliary signal 4 (output).
J22 +VDC supply.
J23 Industrial auxiliary signal 5 (output).
J24 +VDC supply.
J25 Industrial auxiliary signal 6 (output).
J26 +VDC supply.
J27 Industrial auxiliary signal 7 (output).
J28 +VDC supply.
J29 Controlled-current output. This wire terminal connects to an
array of LEDs without series resistors (that is, a
controlled-current array of LEDs). Connect the ground of the
LED lighting device to the J30 wire terminal.
J30 Ground for the controlled-current output.

Breakout board's output connector

The breakout board's output connector is a series of 10 wire terminals. They
connect to your third-party devices so these devices can receive auxiliary output
signals and controlled-current output from your Matrox Iris GT, via an open-wire
Each auxiliary output signal sent to a third-party device requires two wires: one
to carry the signal from your Matrox Iris GT, and one to connect the external
pull-up resistor to +VDC.
For information on using the breakout board's output connector, refer to the
Routing Matrox Iris GT outputs section, earlier in this appendix.
The pinout for the breakout board's output connector is as follows:
Open-wire connectors reference
Matrox Iris GT signal sent
AUX(STB)_OPENC_OUT4
AUX(STB)_OPENC_OUT5
AUX(USER)_OPENC_OUT6
AUX(USER)_OPENC_OUT7
CCS
145
Routed through the
smart camera connector
J8
J9
J10
J11
J12