Removing the thermal sensor board
To remove the thermal sensor board, complete the following steps.
1. Remove the top cover.
See
Removing the top cover
2. Remove the main board top shielding.
See
Replacing the main board
3. On the main board, unplug the thermal-lvps connector.
4. Remove the shielding cover on the left of the power supply.
See
Replacing the DC 12V power supply
5. Remove the one M2.6 screw with a Phillips Jewelers screwdriver securing the thermal sensor
board.
6. Replace the thermal sensor board.
7. To re-install, follow these steps in reverse order.
Replacing the main board
To remove the main board, complete the following steps.
1. Remove the top cover.
See
Removing the top cover
2. To remove the main board top shielding, remove the ten screws with a Phillips #1 screwdriver.
HS Series 2K Service Manual—D13HD2-HS, D13WU2-HS, D16HD-HS, D16WU-HS, D20HD-HS, D20WU-HS
020-001468-02 Rev. 1 (01-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
on page 59.
on page 94.
on page 74.
on page 59.
Printed circuit boards and sensors
94