Removing The Dmd, Dmd Board - Christie H Series Service Manual

5. Remove two lamp cables securing the lamp housing.

Removing the DMD, DMD board

Notice. Failure to comply with the following may result in property damage.
• Must paste a new thermal pad evenly when replacing the DMD module.
• Must paste a new thermal pad when assemble the heat sink.
1. Remove four screws with a M3 screwdriver securing the thermal module.
2. Remove four screws with a M3 screwdriver securing the DMD board.
H Series Service Manual
020-000802-03 Rev. 1 (12-2016)
Parts and module replacement
68