Performing A Network Function Test On Hdbaset Port; Performing A Rs232 And Video Function Test On Hdbaset Port - Christie H Series Service Manual

Performing a network function test on HDBaseT
port
To preform the network function test, complete the following steps.
1. Write down the projector IP.
a. Plug in power cord to the projector, connect the PC and projector by LAN cable.
b. Turn on the projector.
c. On the IR remote keypad, select Menu > Configuration > Communications > LAN.
d. Make sure DHCP is disabled.
e. Write down the following information:
• The IP address: 192.168.0.100 (default)
• The Subnet Mask: 255.255.255.0 (default)
2. Set the projector IP address in the network settings.
See Set the projector IP address in the network settings.
3. Read the projector information.
Internet Explorer version 8 or higher is required.
i
See Read the projector information.
Performing a RS232 and video function test on
HDBaseT port
To preform the RS232 and video function test, complete the following steps.
1. Connect the CH-506TX, projector and PC as shown below.
2. Select the signal source HDBaesT.
3. On the IR remote keypad, press Menu > Configuration > Communications > Serial port
> HDBaseT.
4. Set the PC Baud Rate to 115200.
5. Input the RS232 command (SYS?).
H Series Service Manual
020-000802-03 Rev. 1 (12-2016)
on page 24.
Service setup
on page 24
25