Performing A Rs232 And Video Function Test On Hdbaset Port; On-Screen Display Functionality Inspection - Christie HS 2K Series Service Manual

• The IP address: 192.168.0.100 (default)
• The Subnet Mask: 255.255.255.0 (default)
2. In Network settings, set the projector IP address.
See Performing a network function test on the network port
3. Read the projector information.
See Performing a network function test on the network port
Performing a RS232 and video function test on
HDBaseT port
To perform the RS232 and video function test, complete the following steps.
1. Connect the CH-506TX, projector and PC as shown in step 5.
2. Switch the signal source to HDBaseT.
3. On the IR remote keypad, press the Menu button and select Configuration > Communica-
tions > Serial port > HDBaseT.
4. Set the PC Baud Rate to 115200.
5. Input the RS232 command (SYS?).
The projector returns the following: (SYSx).

On-screen display functionality inspection

All on-screen display functions must be checked for functionality.
ID Check item
1 General
HS Series 2K Service Manual—DWU1612-HS,DWU2022-HS
020-001790-01 Rev. 1 (03-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
RJ45 to HDBaseT port
Power
Check point
When the on-screen display menu is displayed, no visible peaking, ringing,
streaking, or smearing artifacts are on the screen.
on page 35.
on page 35.
RS232 to PC
HDMI input
Service setups
37