Performing A Network Function Test On Hdbaset Port; Performing A Rs232 And Video Function Test On Hdbaset Port - Christie GS Series Service Manual

b. Connect PC and projector using a RJ45 cable.
c. Turn on the projector.
d. On the IR remote keypad, select Menu > Configuration > Communications > LAN.
e. Make sure DHCP is disabled.
f. Write down the following information:
• The IP address: 192.168.0.100 (default)
• The Subnet Mask: 255.255.255.0 (default)
2. In Network settings, set the projector IP address.
a. On the PC, double-click the Local Area Connection.
b. Click Properties.
c. Select Internet Protocol (TCP/IP).
d. Click Properties.
e. Set the IP Address to 192.168.0.240.
f. Set the Subnet Mask to 255.255.255.0.
The Host ID (192.168.0.XXX) of the PC IP Address must be different from the
projector IP address.
g. Click OK.
h. Click Close.
3. Read the projector information.
a. Connect the PC and the projector Ethernet Port with a RJ45 cable.
b. Use Internet Explorer to navigate to http://192.168.0.100.
c. For the Access type, select Administrator.
d. Enter the password admin.
e. Click Login.
Performing a network function test on HDBaseT
port
The following browsers are supported for this test:
• Internet Explorer: IE8 for WinXP, IE9 or higher for Win7, and IE11 for Win8.1 or Win10 is
required.
• Chrome: Version 49 or higher is required.
• Firefox: Version 46 or higher is required.
• Safari: Not supported.
To perform the network function test, complete the following steps.
GS Series 700-850 Service Manual
020-001054-02 Rev. 1 (04-2017)
Service setups
32