Running A Mini Usb Port Performance Test; Completing A Pip/Pbp Function Test; Performing A Network Function Test On The Network Port - Christie GS Series Service Manual

Running a mini USB port performance test

ID Part name
1 Test equipment
2 Test signal
3 Inspection item
4 Inspection distance
5 Criteria
To perform the video performance test by mini USB port, complete the following steps.
1. Connect the projector and PC using a USB cable.
2. Select the signal source Mini USB.
3. From My Computer, execute the Projector Autorun.exe.
The image of PC is projected.

Completing a PIP/PBP function test

Always perform the PIP/PBP function test after repairing the main board, or upgrading the scalar
firmware. If the performance is not normal, replace the main board (see
and I/O board on page 78).
1. On the IR remote keypad, press Menu > Input Switching > PIP Menu.
2. Set PIP/PBP Enable to On.
3. Ensure each item is functioning normally.
Performing a network function test on the
network port
The following browsers are supported for this test:
• Internet Explorer: IE8 for WinXP, IE9 or higher for Win7, and IE11 for Win8.1 or Win10 is
required.
• Chrome: Version 49 or higher is required.
• Firefox: Version 46 or higher is required.
• Safari: Not supported.
To perform the network function test, complete the following steps.
1. Record the projector IP address.
a. Plug in the power cord to the projector.
GS Series 700-850 Service Manual
020-001054-02 Rev. 1 (04-2017)
Description
Video generator
64 Gray RGBW
Mini USB port performance test
1.8 to 2.2 m
No abnormal color performance, line distortion, or noise exist on the screen
Service setups
Replacing the main board
31