Tool Frame - Husqvarna Rider 316T/s AWD Workshop Manual

2. Lay the center belt in place in the center
pulley's bottom groove.
3. Reset the cutting deck to cutting position.

Tool Frame

removal
1. Remove the cutting deck, see "Removing
the Cutting Deck (CombiClip 103,
CombiClip 112)" on page 86.
2. Press down the tool frame and lower the
catch.
3. Measure the adjustment screw positions.
Note the values and use them as initial
values when assembling.
4. Unscrew the adjustment screws
completely so that the springs release.
82
English-
rEPAir iNSTruCTiONS
Intermediate pulley
Tool frame in top position
Check measurement
8009-695
8042-529
8042-330
8009-635