Fitting the Cutting Deck (CombiClip 103, 112)
WArNiNG! use protective goggles when
assembling the cutting deck. The spring
keeping the belt under tension can break
and cause personal injury.
1.
Place the Rider on a level surface and
activate the parking brake.
2.
Make sure the adjustment lever for
cutting height is in its lowest position and
that the lifting lever for the cutting deck is
in cutting position.
3.
Press down the tool frame and put the
catch against the curved bar.
4.
Fasten the belt to the belt holder
5.
Slide in the deck and place the front
guide pins in the groove on the tool
frame, one on each side.
WArNiNG! Take care not to trap your
hand.
84
English-
rEPAir iNSTruCTiONS
8043-921
8042-233
8042-510
8042-235