Autocheck Service Tool; Installation And Login; Product Connections - Husqvarna GARDENA SILENO MINIMO Workshop Manual

Autocheck 3 is a PC tool developed for the service of
the robotic lawn mowers from Husqvarna Group. It is a
tool for troubleshooting as well as a database of sold
products and service history. Autocheck also includes
technical documentation and service bulletins.
Autocheck 3 supports all G3 (Generation 3) and G4
(Generation 4) products. Autocheck EXP is still
applicable for G2 (Generation 2). Autocheck 3 is
regularly updated with new functions and appearance.
The product is connected to the computer using short-
®
range Bluetooth or a USB service cable.

4.1 Installation and login

Autocheck 3 supports Windows OS 7 and later.
Compatibility with other operating systems cannot be
guaranteed.
4.1.1 Getting log in credentials
The log-in credentials determine the set of capabilities
available within Autocheck 3.
To get Autocheck log-in credentials, either contact your
local sales support, or order Autocheck through the
Dealer Portal (requires access).
Note: Distributors can request access to Autocheck
through the Husqvarna IT service portal. Access to
Husqvarna IT service portal can be ordered through the
Husqvarna sales representative.
4.1.2 Installing Autocheck 3
Autocheck 3 is available for downloading from the
manufacturer's support site.
AFTER SALES – Autocheck 3 follow link to
1. Select
SW installation .
2. Download Autocheck 3 according to the instructions
on the Support site.
3. Run the installation file.
4.1.3 Log in to Autocheck 3
1. Start Autocheck.
2. Enter your username and password, refer to
log in credentials on page 9 .
Note: At the first log-in after installation, Autocheck
requires access to internet for user and password
validation.

4.2 Product connections

The product can be connected to Autocheck with both
®
Bluetooth and USB service cable. Tests and firmware
updates are available with both connection methods.
USB service cable connection is faster and
recommended to use.
1595 - 001 - 01.02.2021

4 Autocheck service tool

4.2.1 To connect the product with USB service
cable
1. Remove the rubber plug.
2. Connect the service cable between your computer
3. Start Autocheck on your computer.
4. Switch on the product with the ON/OFF button.
5. After finishing the work in Autocheck, disconnect the
6. Install the rubber plug.
Contact between Autocheck and the product is usually
established automatically and confirmed through the
product's unique identification number.
If contact with the product has not been established:
•
•
4.2.2 To connect the product with Bluetooth
1. Start Autocheck on your computer.
Getting
2. Switch on the product with the ON/OFF button. The
3. The product automatically appears in the list of
4. Press the Connect button for the intended device.
If contact with the product has not been established:
and the product:
cable.
CAUTION: Make sure that the rubber plug
seals fully to prevent moisture inside the
product.
Check that the cable is correctly connected both in
the computer and in the product.
Check that the ON/OFF button is switched on.
product is now pairable through Bluetooth
minutes.
found devices.
The connection between Autocheck and the product
is established automatically. The connection is
confirmed on the Autocheck Home screen.
®
®
for 3
Autocheck service tool - 9