Checking And Adjusting The Cutting Deck - Husqvarna Rider 316T/s AWD Workshop Manual

DELiVEry AND DEALEr SErViCE

Checking and adjusting the cutting deck

Carried out after tire pressures checked. See
"Setting parallelism and cutting height".
Test driving
Fill with gasoline. Run the engine on at least
87 octane unleaded gasoline (not oil mixture).
Environmental alkylate gasoline can be used.
WArNiNG!
Gasoline is highly flammable. Take
care and fill up outdoors.
WArNiNG!
Never run the engine indoors, in
confined or badly ventilated
spaces. Engine exhaust contains
toxic carbon monoxide.
Start the engine
Make sure the machine is in neutral position
and stationary on a level surface with the
parking brake released.
Check the operation of the parking brake.
Check the drive forward (1) and back (2).
Make sure the starter motor does not work
when the parking brake is not applied.
Make sure the engine stops when you get out
of the seat if the parking brake pedal is not
applied.
Make sure the starter motor does not work
with the cutting deck at its lowest position.
Fuel tank
Parking brake
1
Forward and back pedals
Lower the cutting deck
8043-836
8042-009
2
8043-907
25
English-