Replacing The Center Belt - Husqvarna Rider 316T/s AWD Workshop Manual

replacing the Center Belt

1. Remove the rear belt guide for the center
belt.
2. Remove the center belt and fit a new.
3. Assemble and adjust the belt guide to the
lower belt in the engine belt pulley.
4. Check and adjust the belt adjuster. This is
especially important when fitting a new
belt as the lengthening of the old belt
may have been compensated by
changing the setting of the belt adjuster.
The distance between the belt adjuster
and the belt guide must be 17 ±5 mm.
Adjust with the adjustment screw at the
lever carrier.
80
English-
rEPAir iNSTruCTiONS
Adjustment screw
Rear belt guide
Belt guide
Check measure belt adjuster
8009-737
8009-736
8009-842
8009-843