Husqvarna Rider 316T/s AWD Workshop Manual page 108

Microswitch Lifting Lever
1. Loosen the right wing cover.
2. Remove the inner protective plate on the
lever carrier.
3. Unplug the connector from the
microswitch.
4. Remove the microswitch.
Assembly is in reverse order without setting.
Microswitch Seat
1. Raise the seat and remove the spring
disc with spring and spacer sleeve.
Release the microswitch holder.
2. Unplug the cable connections from the
microswitch.
3. Press in the fasteners and remove the
microswitch from the holder.
Assembly is in reverse order without setting.
Microswitch Pedal Carrier
1. Remove the transmission cover.
2. Check the setting of the hydrostat cable.
See "Hydrostat Cable Adjustment".
3. Take the lid off the frame tunnel.
4. Adjust the microswitch so that it clicks
when the parking brake is depressed
about 40 mm / 1,5".
Note: The parking brake cable spring can
be unhooked to improve access.
5. Replace the transmission cover and the
lid over the frame tunnel.
108
English-
ELECTriCAL SySTEM
Microswitch cutting deck
Microswitch: seat
Microswitch pedal carrier
8009-422
8009-424
8009-696