Repair Work; Removing Kawasaki Engine - Husqvarna Rider 316T/s AWD Workshop Manual

Hide thumbs Also See for Rider 316T/s AWD:
Table of Contents

Advertisement

repair Work

removing Kawasaki Engine

1. Remove the engine hood and transmission
cover.
2. Loosen the battery fastening strap. Remove the
protective cover.
iMPOrTANT iNFOrMATiON
Hold the battery cable screws in place so
that the electrodes are not strained.
3. Loosen the battery cable connections. Then lift
out the battery.
4.
Remove the cable between the starter relay
and starter motor from the starter motor.
5. Mark and remove the electrical connections on
the engine.
6. Remove the clips holding the throttle and choke
cables. Unhook the cables from their
attachments on the carburettor.
7. Remove the fuel line hose clip on the fuel pump
and pull down the fuel line. Suspend the hose
to stop fuel leaking.
36
English-
rEPAir iNSTruCTiONS
Battery installation
Engine connections front left
Gas and choke cables
Fuel pump
8009-526
8009-190
8009-527
8009-191

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rider 316txs awdRider 316tRider 316t awdRider 322t

Table of Contents

Save PDF